Materials: All structural members and brackets are constructed of carbon steel. The 10″ guide wheels for DMF RW-1019 railgear are machined from hardened steel castings and are fitted to high strength alloy steel axles with heavy-duty tapered roller bearings.
Installation: Both DMF front and rear guide wheel units bolt to the truck frame using only hand tools found in any shop. They are designed to minimize the amount of space required and in many cases fit within the existing boundaries of the vehicle. The front units, however, sometimes require a bolt-on frame extension to complete the installation. Rear RW-1019 railgear mounts below the top of frame and directly behind the chassis spring hangers. This minimizes intrusion into truck body installations. Please note that center-mounted fuel tanks behind the rear truck axle are not desirable. If possible, opt for the mid-mounted tanks. Rear-mounted tanks can be accommodated by using RW-1019B railgear.
Brakes: RW-1019 rail brakes are hydraulically actuated external shoes. The hydraulic power unit that raises and lowers the railgear also operates the brakes. When the dashboard mounted enable switch is turned on, the brake lamp signal is used as a trigger to run the pump and divert hydraulic pressure to the brakes assisting the existing vehicle brakes when in rail mode. A built in safety circuit protects the truck’s brake lamp system as well as the hydraulic power unit from excessive run times.
Operation: The truck is pulled onto a crossing and the wheels aligned to the tracks with attention being paid to the front. The operator then activates the hydraulic power unit by pressing the button on the front bumper and pulling the lever of the hydraulic valve to raise the railgear off of the pin-off device. The safety pins are removed and the lever pushed forward lowering the rail wheels to the track. The front gear will lift the front of the truck and go over center. The rear is operated similarly. The gear is raised to lift the weight from the pin-offs, and the pins are removed. The gear is then lowered via the two handled valve at the rear of the truck. Each spool may be operated independently to articulate the rear gear and engage the rail even if the rear wheels are not perfectly aligned. Once the rear gear is fully deployed, the pin-offs are re-inserted to lock the gear in place.
Steering Wheel Lock: A steering wheel lock is provided, requiring no modifications to the column.
